Connect the LAN connector and unconnect/connect the power cable to reboot zig-sw41. Open telnet connection to zig-sw41. For example, on windows, launch "telnet" and type "open sw41-xxxx" where xxxx are the last four numbers of the products serial number. For example, for zig-sw41 with a serial number 151870000055 use "open sw41-0055" Once telnet session is open you can type in the commands. The commands are the same as with RS232 but there is no need to add the @sw41 directive in the front. Simple only use the actual commands: IP Control Commands: help: print this summary usage: help disco: Ukko Discovery usage: disco returns other zigen ecosystem products if connected uptime: System uptime usage: uptime version: Firmware Version usage: version insel: HDMI Input Selection usage: insel <1|2|3|4> st: Get Device Status usage: st man: Display Device Info usage: man power: power ZIG-SW41 on/off usage: power Examples: power off Will turn off the power for the connected zig-sw41. insel 3 will select the HDMI input 3 for the connected sw41 device